GETTING STARTED?EASY.User ManualZGO76534EN User ManualHobGB IE
INSTALLATIONWARNING! Refer to Safety chapters.BEFORE THE INSTALLATIONBefore you install the hob, write down theinformation bellow from the rating plat
or they are not squeezed. Also be careful when thehob is put together with an oven.CAUTION! It is important to install theelbow correctly, with the sh
Before carrying out the connection, make sure:1. The limiter valve and the electrical system cantake the appliance load (see the rating plate)2. The s
BUILDING INmin. 55 mmmin. 650 mm560 mmmin. 150 mm30 mm480 mmmin. 600 mmABA) supplied sealB) supplied bracketsCAUTION! Install the appliance onlyon a w
BURNER Ø BYPASS 1/100 mmSemi-rapid 32Auxiliary 28OTHER TECHNICAL DATATOTAL POWER:Gas original: G20 (2H) 20 mbar = 10,5 kWGas replacement: G30 (3+) 28-
Type of hob Built-in hobNumber of gas burners 5Energy efficiency per gas burner(EE gas burner)Left middle - Triple Crown 53.2%Centre rear - Semi-r
WWW.ZANUSSI.COM/SHOP867321717-A-302015
SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if a
• Do not use a steam cleaner to clean the appliance.• If the glass ceramic surface / glass surface is cracked, switchoff the appliance to avoid the po
• Make sure that the electrical information on therating plate agrees with the power supply. If not,contact an electrician.• Make sure the appliance i
• Use only stable cookware with the correctshape and diameter larger than the dimensionsof the burners.• Make sure cookware is centrally positioned on
Symbol Descriptionminimum gas supplyDAILY USEWARNING! Refer to Safety chapters.BURNER OVERVIEWABCA) Burner cap and crownB) ThermocoupleC) Ignition can
If after some tries the burner does notlight, check if the crown and its capare in correct positions.WARNING! Do not keep the controlknob pushed for m
CARE AND CLEANINGWARNING! Refer to Safety chapters.GENERAL INFORMATION• Clean the hob after each use.• Always use cookware with clean bottom.• Scratch
Problem Possible cause Remedy The fuse is released. Make sure that the fuse is thecause of the malfunction. If thefuse releases again and again,conta
Comentarios a estos manuales