Zanussi ZGX9641F Manual de usuario descargar pdf (Pagina 3)

ENVIRONMENT PROTECTION

Packing disposal

Sort packing into different materials (cardboard, polystyrene

etc.) and dispose of them in accordance with local waste

disposal laws.

This appliance must only be used for the purpose of domestic

cooking.

WORK-TOP USE

USING GAS BURNERS

The following symbols are on the control panel next to each knob:

- Black circle gas off

- Large flame maximum setting

- Small flame minimum setting

The minimum position is at the end of the anti-clockwise rotation

of the knob. All operation positions must be chosen between the

positions of max. and min., never choose them between max. and

off.

MANUAL IGNITION

To turn on a burner, approach a match to it, press the knob

corresponding to the selected burner and turn it anticlock-wise to

the maximum position.

ELECTRIC IGNITION (Optional)

To turn on a burner, press the knob corresponding to the selected

burner and turn it anticlockwise to the maximum position;

simultaneously pressing the electric ignition button on the control

panel marked with .

In case there is no electric current, the burner can also be lighted

using a match.

AUTOMATIC ELECTRIC IGNITION (Optional)

To turn on a burner, press the knob corresponding to the selected

burner and turn it anticlockwise to the maximum position. Keeping

the knob pressed, the electric automatic ignition of the burner will

be started up. In case there is no electric current, the burner can

also be lighted using a match.

APPLIANCES WITH SAFETY VALVE

Follow the same procedure described above to ignite the burners.

In this case, however, once you have turned the knob to the open

setting, hold it pressed in for 10 seconds. If for any reason the

burner flame goes out, the safety valve automatically shuts off the

gas supply to the burner in question.

ENERGY SAVING TIPS

. The diameter of the pan bottom should be the same as that

of the burner. The burner flame must never come out from the

pans diameter.

. Use flat-bottomed pans only.

. Whenever possible, keep a lid on the pan while cooking.

You will not need as much heat.

. Cook vegetables, potatoes, etc. with as little water as possible

to reduce cooking times.

Max

Min

Max

Min

GENERAL INFORMATION DESTINED

TO THE END USER

FIRST PART

THIS APPLIANCE HAS BEEN CONSTRUCTED AND

DISTRIBUTED IN COMPLIANCE WITH:

- The safety requirements of Directive 73/23/EEC

regarding “Low Voltages”.

- The requirements of Directive 89/336/EEC

regarding “Electromagnetic Compatibility”.

- The safety requirements of Directive 90/396/EEC

regarding “Gas Appliances”.

- Directive 89/109/EEC

regarding “Materials that can touch food”

- Moreover the above mentioned Directives comply with Directive

93/68/EEC.

This cooker is of type “X” with regard to protection against over

heating of surraounding surfaces.

DEAR CUSTOMER,

. Carefully read these instructions before using the appliance and

keep them for future consultation.

. Keep potentially hazardous packaging (plastic bags, polystyrene

etc.) out of the reach of children.

WARRANTY

Your new appliance is covered by a warranty.

The warranty certificate is herewith enclosed. If it is missing, ask

the retailer for it indicating purchasing date, model, and data plate

number which are printed on the data nameplate identifing the

appliance. Keep the smallest part of the certificate, and in case

of necessity, show it to the Technical Service together with the

receipt or the delivery bill. If you do not follow this procedure, the

technical service will be compelled to charge you with all the fees

of each eventual reparation.

AFTER SALES SERVICE

The excellent quality and advanced technology of our appliances

guarantee their perfect operation.

If, however, a fault occurs, try and remedy it by checking if you

have correctly followed all the instructions indicated in this

instructions booklet.

If, after consulting these instructions and checking the gas and

electrical connections, the fault persists, contact our After Sales

Service for prompt technical assistance.

The diameter of the

recommended pans is:

RAPID from 20 to 24 cm

SEMIRAPID from 18 to 20 cm

AUXILIARY from 12 to 18 cm

APPLIANCE MAINTENANCE

A) On the lower plate of the hob, on the outside there are some

visible screws fixing the burners and the gas manifolds to the

chassis or some screw-nuts fixing the electrical plates for all

electric or combined versions.

Once these screws or screw-nuts are unscrewed, it is possible

to replace the components inside the hob (see picture below).

GREASING OF TAPS

If a tap becomes hard to be turned, grease it using a specific

grease withstanding high temperatures.

Act as follows:

- Switch the appliance off and close the gas tap.

- Remove knobs, grids, burners and flame-spreaders.

- Follow the indications od point A and B.

- Unscrew the two fixing screws V from the burner body A (see

picture) and remove the cone C.

B)The hob is fixed in its upper part to the burners by means of

some visible screws. If these screws and the nut blocking the

taps to the hob are screwed, it is possible to open the appliance

and to reach the inside components (see picture below).

- Clean the cone C and its slot by means of a cloth soaked with

diluent.

- Slightly grease the cone with the relevant grease, put it in its

slot, and turn it some times.

- Remove the cone again, remove the exceeding grease making

sure the gas entries are not obstructed by grease residuals.

- Assemble everything carefully in the opposite direction.

TAPS REPLACEMENT

Act as follows:

- Switch the appliance off, and close the general gas tap.

- Remove knobs, grids, burners and flame-spreaders.

- Disassemble the upper hob as previously described.

- Follow the indications written in paragraphs A and B.

- Unscrew nut L of the gas tube to the burner and disassemble

the gas manifold from the hob lower plate.

- Unscrew screws R fixing the tap to the bridle and remove the

last (see picture).

Note: Every time the tap is replaced, it is necessary to replace

seal gasket D too (see picture).

Once you have finished this procedure, re-assemble

everything in the opposite sense, having care to check with

water and soap the gas circuit seal.

WARNINGS

Before performing any repair or operation, switch the appliance

off and close the gas tap.

The manufacturer declines all responsibility for any damage to

persons, animals or things caused by failure to observe the rules

indicated above.

In case it is necessary to repair or replace the inside components,

act as follows:

DISASSEMBLE OF WORK-TOP

- disconnect the electrical supply cable

- disconnect the gas supply tube

- remove the grids

- remove burners and flame-spreaders

- remove the knobs from the facia-panel

- disassemble the work-top from the cabinet unscrewing screws

Z blocking locking bridles Y (see paragraph “Assemblage and

installation of the appliance”.

Remove the hob from the top.

- Unscrew the screw " A ".

- Open the door " B ".

- Unscrew cover " C ".

- Insert battery " D ".

(1x AA size battery, whit positive terminal turned in the direction

of the cover " C ").

- Remount everything by following the inverted operations.

D C

VERSION WiTH BATTERY IGNITION

Change of battery

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Zanussi ZGX9641F Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZGX9641F