Zanussi ZDT13012FA Manual de usuario

ENUser manualDishwasherZDT13012FA

Cleaning the filters1CBA2345D678To remove filters (B) and (C), turn the handlecounterclockwise and remove. Pull apart filter(B) and (C). Wash the filt

Alarm code Problem• The end indicator flashes 1 time intermittently.• Acoustic signal sounds 1 time intermittently.The appliance does not fill with wa

Refer to ‘HINTS AND TIPS’ for other pos-sible causes.Technical informationDimensions Width / Height / Depth (mm) 596 / 818 - 898 / 555Electrical conne

13www.zanussi.com

14 www.zanussi.com

15www.zanussi.com

www.zanussi.com/shop 156970830-A-342013

ContentsSafety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

• The water inlet hose has a safety valve anda sheath with an inner mains cable.Warning! Dangerous voltage.• If the water inlet hose is damaged, immed

1On/off button2Programme indicators3Indicators4Programme button5Delay buttonIndicators DescriptionEnd indicator.Rinse aid indicator. This indicator is

OptionsAcoustic signalsThe acoustic signals operate when the appli-ance has a malfunction and it is not possibleto deactivate them.There is also an ac

Water hardnessWater softeneradjustmentGermandegrees(°dH)Frenchdegrees(°fH)mmol/l ClarkedegreesLevel37 - 42 65 - 75 6.5 - 7.5 46 - 52 829 - 36 51 - 64

Filling the rinse aid dispenser1212 12343214To adjust the released quantity of rinse aid,turn the selector between position 1 (lowestquantity) and po

2. Make sure that the salt container and therinse aid dispenser are full.3. Start the shortest programme with a rins-ing phase, without detergent and

Hints and tipsThe water softenerHard water contains a high quantity of miner-als that can cause damage to the applianceand bad washing results. The wa