Zanussi ZCM660NWC Manual de usuario descargar pdf (Pagina 15)

3. Close the door.

4. Set an oven function.

5. Set the oven temperature to 250 °C and

let the oven operate for 1 hour.

6. Clean the oven cavity with a soft and damp

sponge.

Caution! Do not attempt to clean catalytic

surfaces with oven sprays, abrasive

cleaners, soap or other cleaning agents. This

may damage the catalytic surface.

Discolouration of the catalytic surface has

no effect on catalytic properties.

Oven lamp

Warning! Be careful when you change

the oven lamp. Always switch off the

appliance before you start to replace the lamp.

There is a risk of electric shock.

Warning! Bulb lamps used in this

appliance are special lamps for use only in

household appliances. Do not use them to

illuminate household rooms or parts of rooms. If

you need to replace a lamp, the replacement

lamp must have the same power and be for use

only in household appliances.

Before you change the oven lamp:

• Deactivate the appliance.

• Remove the fuses in the fuse box or deacti-

vate the circuit breaker.

• Put a cloth on the bottom of the oven. This

prevents from damage to the oven light and

glass cover.

Replacing the oven lamp:

1. Find the lamp glass cover at the back of

the cavity.

Turn the lamp glass cover counterclock-

wise to remove it.

2. Clean the glass cover.

3. Replace the oven lamp with an applicable

300 °C heat-resistant oven lamp.

Use only the same oven lamp type as the

replacement lamp. It must have the same

power and be for use only in household

appliances.

4. Install the glass cover.

What to do if…

Problem Possible cause Remedy

There is no spark when light-

ing the gas

There is no electrical supply Make sure that the unit is connected and the

electrical supply is switched on.

There is no spark when light-

ing the gas

There is no electrical supply Examine the house electrical installation

fuse.

There is no spark when light-

ing the gas

Burner cap and crown are

placed uneven

Make sure that the burner cap and crown

are in correct positions.

The flame is blow out immedi-

ately after ignition

Thermocouple is not heated

sufficient

After lightning the flame, keep the knob

pushed for approximately 5 seconds.

The gas ring burns unevenly Burner crown is blocked with

food residues

Make sure that the injector is not blocked

and the burner crown is clear of food parti-

cles.

The appliance does not oper-

ate

The fuse in the fuse box is

released

Control the fuse. If the fuse is released more

than one time, refer to a qualified electrician.

The oven does not heat up The oven is not switched on Switch on the oven.

The oven does not heat up The necessary settings are

not set

Control the settings.

www.zanussi.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comentarios a estos manuales

Sin comentarios

Zanussi ZCM660NWC Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCM660NWC