Zanussi ZCV65310WA Manual de usuario descargar pdf (Pagina 7)

Before first use

Warning! Refer to the Safety chapters.

Initial Cleaning

• Remove all parts from the appliance.

• Clean the appliance before first use.

Important! Refer to chapter "Care and

Cleaning".

Setting the time

You must set the time before you operate

the oven.

When you connect the appliance to the electri-

cal supply or after a power cut, the indicator for

the Time of Day function flashes.

Press the + or - button to set the correct time.

After approximately five seconds, the flashing

stops and the display shows the time of day you

set.

To change the time, press

again and

again until the indicator for the Time of Day

function flashes. You must not set the Duration

or End function at the same time.

To use the appliance, push the knob. The knob

comes out.

Preheating

Set function

and maximum temperature.

2. Run an empty oven for 45 minutes.

Set function

and maximum temperature.

4. Run an empty oven for 15 minutes.

This is to burn off any residue from the cavity

surface. Accessories can become more hot

than in normal use. During this period an odour

and smoke can be emitted. This is normal. Make

sure the airflow is sufficient.

Hob - Daily use

Warning! Refer to the Safety chapters.

Heat settings

Control knob Function

Keep warm setting

0 Off position

1-9 Heat settings

(1 = lowest heat setting; 9 = highest heat setting)

1. Turn the control knob to a necessary heat

setting.

2. To complete the cooking process, turn the

control knob to the “0” position.

Residual heat indicator

The residual heat indicator comes on when a

cooking zone is hot.

Warning! Risk of burns from residual heat!

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Comentarios a estos manuales

Sin comentarios

Zanussi ZCV65310WA Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCV65310WA