Zanussi ZGG62414XA Manual de usuario descargar pdf (Pagina 4)

Installation

WARNING!

Only a qualified person must install

this appliance.

• Remove all the packaging.

• Do not install or use a damaged appliance.

• Follow the installation instruction supplied

with the appliance.

• Keep the minimum distance from the other

appliances and units.

• Always take care when moving the appliance

as it is heavy. Always use safety gloves and

enclosed footwear.

• Seal the cut surfaces with a sealant to

prevent moisture to cause swelling.

• Protect the bottom of the appliance from

steam and moisture.

• Do not install the appliance adjacent to a

door or under a window. This prevents hot

cookware to fall from the appliance when the

door or the window is opened.

• If the appliance is installed above drawers

make sure that the space, between the

bottom of the appliance and the upper

drawer, is sufficient for air circulation.

• The underside of the appliance can get hot

when in use. If an oven has not been fitted

underneath the hob and underside of the

appliance is accessible and could allow a

user or items stored beneath the hob to

come in direct contact with the underside of

the hob, an intermediate protection panel

must be fitted.

• Plywood or kitchen carcass material is

acceptable for the panel.

• The panel must be removable for servicing.

Screws used to fix the panel must be

accessible after installation.

Electrical Connection

WARNING!

Risk of fire and electrical shock.

• All electrical connections should be made by

a qualified electrician.

• The appliance must be earthed.

• Before carrying out any operation make sure

that the appliance is disconnected from the

power supply.

• Make sure that the electrical information on

the rating plate agrees with the power

supply. If not, contact an electrician.

• Make sure the appliance is installed

correctly. Loose and incorrect electricity

mains cable or plug (if applicable) can make

the terminal become too hot.

• Use the correct electricity mains cable.

• Do not let the electricity mains cable tangle.

• Make sure that a shock protection is

installed.

• Use the strain relief clamp on the cable.

• Make sure the mains cable or plug (if

applicable) does not touch the hot appliance

or hot cookware, when you connect the

appliance to the near sockets

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

mains plug (if applicable) or to the mains

cable. Contact our Authorised Service

Centre or an electrician to change a

damaged mains cable.

• The shock protection of live and insulated

parts must be fastened in such a way that it

cannot be removed without tools.

• Connect the mains plug to the mains socket

only at the end of the installation. Make sure

that there is access to the mains plug after

the installation.

• If the mains socket is loose, do not connect

the mains plug.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• Use only correct isolation devices: line

protecting cut-outs, fuses (screw type fuses

removed from the holder), earth leakage trips

and contactors.

• The electrical installation must have an

isolation device which lets you disconnect

the appliance from the mains at all poles.

The isolation device must have a contact

opening width of minimum 3 mm.

Gas connection

• All gas connections should be made by a

qualified person.

• Before installation, make sure that the local

distribution conditions (nature of the gas and

gas pressure) and the adjustment of the

appliance are compatible.

• Make sure that there is air circulation around

the appliance.

• The information about the gas supply is on

the rating plate.

• This appliance is not connected to a device,

which evacuates the products of

combustion. Make sure to connect the

4 www.zanussi.com

1 2 3 4 5 6 7 8 9 ... 19 20

Comentarios a estos manuales

Sin comentarios

Modelos	Tipo de documento
SeaTalk-SeaTalk ng	Especificaciones Raymarine SeaTalk-SeaTalk ng Specifications, 28 paginas
SmartPilot SPX-30	Manual de usuario SPX SmartPilot System Installasjon SPX 10, SPX 30, 54 paginas
ST1000+	Especificaciones Raymarine ST1000+ Specifications [en] , 8 paginas
ST1000 Plus	Especificaciones Raymarine ST1000 Plus Specifications, 76 paginas
ST2000+	Manual de usuario Installer et utiliser un pilote ST2000+ sur un First 30, 7 paginas
ST40	Especificaciones Raymarine ST40 Product specifications, 43 paginas Especificaciones Raymarine ST40 Product specifications, 53 paginas Manual de usuario ST40 BIDATA manuale, 56 paginas
ST50 plus	Especificaciones Raymarine ST50 plus Product specifications, 21 paginas Manual de usuario Distributed by Any reference to Raytheon or RTN in this, 18 paginas
ST60	Manual de instalación Raymarine ST60 Installation manual, 50 paginas Especificaciones Raymarine ST60 Specifications, 52 paginas Especificaciones Raymarine ST60 Specifications, 54 paginas
ST70	Guía de instalación Raymarine ST70 Installation guide [de] [en] [fr] , 26 paginas Guía de instalación Raymarine ST70 Installation guide, 48 paginas
ST70 Instrument	Manual de usuario Raymarine ST70 Instrument User manual, 12 paginas Guía de instalación Raymarine ST70 Instrument Installation guide, 28 paginas
ST80	Guía de instalación Raymarine ST80 Installation guide, 15 paginas

Zanussi ZGG62414XA Manual de usuario Pagina 4

Comentarios a estos manuales

Raymarine No manuales de usuario

Zanussi ZGG62414XA Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZGG62414XA

Raymarine No manuales de usuario