Zanussi ZGG782CTN Manual de usuario descargar pdf (Pagina 29)

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

To light a burner, turn the relevant knob anticlockwise to maximum position

( )and push down the knob to ignite.

Upon ignition, keep the knob pushed down

about 5 seconds. This will allow the

"thermocouple" (lett. D) to be heated and the

safety device to be switched off, otherwise

the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after several

attempts, check the "cap" (lett. A) and the

"crown" (lett. B) are in the correct position.

To put the flame out, turn the knob to the

symbol .

In the absence of electricity, ignition can occur

without the electrical device; in this case

approach the burner with a flame, push the

relevant knob down and turn it anti-clockwise

until it reaches the "maximum" position.

Always turn the flame down or put it out

before taking the pans off the burner.

Do not keep the control knob pressed for

more than 15 seconds.

If the burner does not light even after 15

seconds, release the control knob, turn it

the “off” position and wait for at least 1

minute before trying to light the burner

again.

Operation

))

)

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

triple crown

burner

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Comentarios a estos manuales

Sin comentarios

Zanussi ZGG782CTN Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZGG782CTN