Zanussi ZGH65414XB Manual de usuario

GETTING STARTED?EASY.User ManualZGH65411XBZGH65414XBZGH65414XXEN User ManualHobGB IE

9.CAUTION! Install the appliance onlyon a worktop with flat surface.POSSIBILITIES FOR INSERTIONThe panel installed below the hob must be easy toremove

CONTROL KNOBSymbol Descriptionno gas supply / off positionignition position / maximumgas supplySymbol Descriptionminimum gas supplyDAILY USEWARNING! R

TURNING THE BURNER OFFTo put the flame out, turn the knob to the offposition .WARNING! Always turn the flamedown or switch it off before youremove th

Be very careful when you replacethe pan supports to prevent thehob top from damage.2. The enamel coating occasionally can haverough edges, so be caref

Problem Possible cause Remedy The fuse is blown. Make sure that the fuse is thecause of the malfunction. If thefuse is blown again and again,contact

TECHNICAL DATAHOB DIMENSIONSWidth 595 mmDepth 510 mmBYPASS DIAMETERSBURNER Ø BYPASS 1/100 mmRapid 42Semi-rapid 32Auxiliary 28OTHER TECHNICAL DATATOTAL

GAS BURNERS FOR LPG G30/G31 28-30/37 mbarBURNERNORMALPOWER kWMINIMUMPOWER kWINJECTORMARKNOMINAL GAS FLOW g/hG30 28-30 mbar G31 37 mbarRapid 2,8 0,75 8

17

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP867345145-C-362018

• NEVER try to extinguish a fire with water, but switch off theappliance and then cover flame e.g. with a lid or a fire blanket.• CAUTION: The cooking

• Do not install the appliance adjacent to a dooror under a window. This prevents hot cookwarefalling from the appliance when the door or thewindow is

• Used oil, that can contain food remnants, cancause fire at a lower temperature than oil usedfor the first time.• Do not put flammable products or it

813 Current Editions and the ETCI Rules forElectrical Installations.Provision for ventilationDetailed recommendations are contained in thefollowing Br

4. Assemble the parts, follow the same procedurebackwards.5. Replace the rating plate (it is near the gassupply pipe) with the one for the new type of

• N — Neutral terminal• or E — Earth terminalBefore carrying out the connection, make sure:1. The limiter valve and the electrical system cantake the

ASSEMBLY1.2.3.min. 55 mmmin. 650 mm560 mm20+min. 100 mm30 mm480 mm20+min. 600 mm4.50 mm400 mmIf a furniture unit is installed at adistance of 400