Zanussi ZGL62IW Manual de usuario descargar pdf (Pagina 8)

Lighting the burnersLighting the burners

Lighting the burners

For easier lighting, proceed before putting a pan on the panFor easier lighting, proceed before putting a pan on the pan

For easier lighting, proceed before putting a pan on the pan

support.support.

support.

To light a burner:

# push the electric ignition button which is marked by a little spark.

# at the same time, turn the relevant control knob anti-clockwise to

maximum position and keep it pushed down until the burner does not

ignite.

# Then, check that the flame is regular adjust it as required.

If the burner does not ignite, turn the control knob to zero, and try again.

If you cannot light the flame even after

severalattempts, check the "cap" (Fig. 1

lett. A) and the"crown" (Fig. 1 lett. B) are in

the correct position.

When switching on the mains, after

installation or a power cut, it is quite normal

for the spark generator to be activated

automatically.

In the absence of electricityIn the absence of electricity

In the absence of electricity, ignition

can occur without the electrical device; in

this case, approach the burner with a

flame, push the relevant knob down and

turn it anti-clockwise until it reaches the

maximum position.

If the control knobs become difficult to

turn, please contact your local Service

Force Centre.

OperationOperation

Operation

Fig. 1

A - Burner cap

B - Burner crown

C - Ignition electrode

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sin comentarios

Zanussi ZGL62IW Manual de usuario Pagina 8