Zanussi ZKF65LN Manual de usuario descargar pdf (Pagina 9)

Whenbuildinginceramicglasscookingareasthefront

cross-rail of the build-in cupboard must be removedin

orderto havethe heat radiating offescape withoutany

obstacles.

The space under the hob unit must be closed at all

sides in a way that the lower side of the cooking area

is no longer accessible.

The distance from the hob to the furniture part under

the hob must at least amount to 20 mm. If needed,

please fix an insulation. Drawers must not be located

under a hotplate.

The distance from the hob to a high cupboard beside

right or left must at least amount 55 mm, to the back

wall at least amount 55 mm.

With regard to the protection against overheating of

surrounding furniture surfaces this appliance corres-

ponds to type Y (EN 60335). This appliance or the

built--incupboardfortheappliancerespectivelymaybe

locatedwiththerearwallandonesidewalltowhatever

high walls or furniture respectively and with the other

side to another appliance or furniture of the same

height as this appliance.

Built-in dimensions

The opening in the worktop must correspond to com-

mercialdimensions.Thehintsrequiredaregiveninthe

dimension sketch.

Built-in

Cutoutthe worktopacc. toprescribedcutout size.The

tolerance sizes must not be exceeded. Do precisely

saw at the mark line. Recommendation: Mark the cut-

out with a steel needle. Glue something on the line in

order to avoid shattering of the coat when cutting.

With tile--coatedworktop areasthe slits in thesupport-

ing area for the cooking area must be filled up com-

pletely.

Clean the worktop in the cutout area

Fromthetoplaythecookingareaintothecutout,adjust

concentrically and firmly press down.

Check the sealing in the supporting frame for perfect

seating and restingwithout a gap. Please do not apply

additional silicone sealing material, the closure will

makeit harderto dismantleincaseofneedforservice.

5 holes in the bottom of the build--in case are provided

for the screws of the fitting plates.

At first screw on the fitting plates by a screwdriver and

afterwardsregularlytightentheplatesalternativelyand

diagonally offset, until the frame of the cooking areais

perfectly laying on the worktop.

Atoostrongandone--sidedtighteningisto beavoided!

Electric screwdrivers or pusher airscrews to be exclu-

sively used with slip clutch (setting value 1 -- 1.1 Nm).

Worktop opening:

width: 560 mm

depth: 490 mm

radius: 5 mm

Appliance:

width: 572 mm

depth: 502 mm

heigth : 49 mm

Voltage: AC 230 V 50 Hz/60 Hz

Total connected load: 5.9 kW

572

502

heigth of the hob

49 mm

heigth of frame

over worktop

3 mm

Frame measurement

on worktop 9 mm

hobs frame

ceramic glass plate

fixing clamp

Points for fixing clamps

Measurement of

490 ±1560 ±1

49 mm

worktop

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Zanussi ZKF65LN Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZKF65LN