Zanussi ZCC6600X Manual de usuario descargar pdf (Pagina 24)

Electrical connections

Prior to making the electric al connection, make

sure that:

- The protection fuse and the domestic wire

system are suitable to carry the total electric load

of the oven (see rating plate).

- Your domestic wiring system has an efficient

earth connection in compliance with the rules

and laws in force.

- The wall socket or the omnipole switch used for

the electrical connection can easily be reached

after the oven is built in.

The appliance is delivered without an electric

supply cable, therefore, you will have to fit to it a

supply cable with standard plug, suitable for the total

electric load shown on the rating plate.

The plug is to be inserted into a suitable wall

socket.

If you require a direct connection to the electric

network (mains), it will be necessary to fit between

the appliance and the mains an omnipole switch, aith

a minimum gap between contacts of 3 mm. suitable

for the required load and in compliance with rules in

force. The green 1 yellow ground wire must not be

interrupted by the switch.

The supply cable must in all cases be laid out in

such a way as to ensure that it does not reach at any

given point a temperature 50°C higher than the

ambient temperature.

The manufacturer disclaims any liability in

case these accident-preventing rules are not

observed.

Suitable power supply cables are the following

types, considering the respective necessary section

of cable.

• H07 RN-F

• H05 RN-F

• H05 RR-F

• H05 VV-F

• H05 V2V2-F (T90)

Connecting the terminal board

The appliance incorporates an easily accessible

6-pole terminal board whose jumpers (bridges) are

already pre-set for operation on 400 V three-phase

with neutral wire. In case where different mains

voltage is present, the jumpers on the terminal board

must be arranged as shown in the diagram.

The ground cable must be connected to terminal

After connecting the supply cable to the terminal

board, secure it with a junction clamp.

230V 3~

1 2 3 4 5

L1 L2 L3 PE

230V 1~

1 2 3 4 5

L1 N PE

400V 2N~

1 2 3 4 5

L1 L2 N PE

400V 3N~

1 2 3 4 5

L1 L2 L3 N PE

Section

of cable

(min.)

4 x 1.5 mm

Section

of cable

(min.)

3 x 2.5 mm

Section

of cable

(min.)

4 x 2.5 mm

Section

of cable

(min.)

5 x 1.5 mm

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Comentarios a estos manuales

Sin comentarios

Zanussi ZCC6600X Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCC6600X