
Problem Possible cause Remedy
The sensor fields become hot. The cookware is too large or
you put it too near to the con-
trols.
Put large cookware on the rear
zones if possible.
comes on the hob display.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on the hob display.
The Child Safety Device or the
Lock function operates.
Refer to "Hob - Daily use"
chapter.
comes on the hob display.
There is no cookware on the
zone.
Put cookware on the zone.
comes on the hob display.
The cookware is incorrect. Use the correct cookware.
Refer to "Hob - Hints and tips"
chapter.
comes on the hob display.
The diameter of the bottom of
the cookware is too small for
the zone.
Use cookware with correct di-
mensions.
Refer to "Hob - Hints and tips"
chapter.
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not
set.
Make sure that the settings are
correct.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows "12.00". There was a power cut. Reset the clock.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
23
Comentarios a estos manuales