Zanussi ZGG35214 Manual de usuario descargar pdf (Pagina 10)

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• This appliance is supplied with a mains ca-

ble. It has to be supplied with a correct plug

which can hold the load that the rating plate

rates. Make sure that you install the plug in a

correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

To prevent contact between the cable and the

appliance below the hob use the clamps which

are on the side of the cabinet.

A

A) Rigid copper pipe or flexible pipe of stain-

less steel

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Building In

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

270 mm

If several 30 cm hobs are to be installed side by

side into the same cut out, an assembly kit in-

cluding a support side bracket and supplemen-

tary seals is available at our Service Centres.

The relevant installation instructions are sup-

plied within the kit package.

A

B

A) supplied seal

B) supplied bracket

Caution! Install the appliance only on a

worktop with flat surface.

If you install the hob under a hood, please

see the installation instructions of the hood

for the minimum distance between the applian-

ces.

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

10

www.zanussi.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios