Zanussi ZGL62ITX Manual de usuario descargar pdf (Pagina 8)

Lighting the burnersLighting the burners

Lighting the burners

For easier lighting, proceed before putting a pan on the panFor easier lighting, proceed before putting a pan on the pan

For easier lighting, proceed before putting a pan on the pan

support.support.

support.

To light a burner:

z Turn the relevant knob anti-clockwise to maximum position( ), then

push it down to ignite the burner.

Only for Model ZGL62 IT:Only for Model ZGL62 IT:

Only for Model ZGL62 IT: turn the relevant control knob anti-

clockwise to maximum position and keep it pushed down about 5

seconds. This will allow the "thermocouple" (see Fig. 1 - lett.

D) to be

heated and the safety device to be switched off, otherwise the gas

supply would be interrupted.

z Then, check that the flame is regular adjust

it as required.

z To put the flame out, turn the knob to the

symbol

If the burner does not ignite, turn the control

knob to zero, and try again.

If you cannot light the flame even after

severalattempts, check the "cap" (Fig. 1

lett.

A) and the"crown" (Fig. 1 lett.

B) are in

the correct position.

When switching on the mains, after

installation or a power cut, it is quite normal

for the spark generator to be activated

automatically.

In the absence of electricityIn the absence of electricity

In the absence of electricity, ignition

can occur without the electrical device; in

this case, approach the burner with a

flame, push the relevant knob down and turn it anti-clockwise until it

reaches the maximum position.

Do not keep the control knob pressed for more than 15

seconds. If the burner does not light even after 15 seconds,

release the control knob, turn it the "off" position and wait for

at least one minute before trying to light the burner again.

If the burner accidentally goes out, turn the control knob to the

“off” position and wait for at least 1 minute before trying to light the

burner again.

Operation

)

Fig. 1

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple (ZGL62 IT)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comentarios a estos manuales

Sin comentarios

Zanussi ZGL62ITX Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZGL62ITX