Zanussi ZGO62414BA Manual de usuario

GETTING STARTED?EASY.User ManualZGO62414BAEN User ManualHobEG

LABELS SUPPLIED WITH THE ACCESSORIESBAGStick the adhesive labels as indicated below:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03

A B CA. End of shaft with nutB. Washer supplied with the applianceC. Elbow supplied with the applianceLiquid gasUse the rubber pipe holder for liquid

• Do not let the power cable to heat up to atemperature higher than 90° C.Make sure that you connect the blueneutral cable to the terminal with alette

7.min.12 mmCAUTION! Install the appliance onlyon a worktop with flat surface.POSSIBILITIES FOR INSERTIONKitchen unit with doorThe panel installed belo

BYPASS DIAMETERSBURNER Ø BYPASS 1/100 mmRapid 42Semi-rapid 32Auxiliary 28OTHER TECHNICAL DATATOTAL POWER:Gas original: G20 (2H) 20 mbar 7,7 kWGas repl

Return the product to your local recycling facility orcontact your municipal office.15*

WWW.ZANUSSI.COM/SHOP867345615-A-132018

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

• NEVER try to extinguish a fire with water, but switch off theappliance and then cover flame e.g. with a lid or a fire blanket.• CAUTION: The cooking

SAFETY INSTRUCTIONSThis appliance is suitable for the following markets:EGINSTALLATIONWARNING! Only a qualified personmust install this appliance.WARN

USEWARNING! Risk of injury, burns andelectric shock.• Remove all the packaging, labelling andprotective film (if applicable) before first use.• This a

• Disconnect the appliance from the mainssupply.• Cut off the mains electrical cable close to theappliance and dispose of it.• Flat the external gas p

BURNER OVERVIEWABDCA. Burner capB. Burner crownC. Ignition candleD. ThermocoupleIGNITION OF THE BURNERAlways light the burner before you puton the coo

WARNING! Do not put the same panon two burners.WARNING! Do not put unstable ordamaged pots on the burner toprevent spills and injuries.CAUTION! Make s

CLEANING THE SPARK PLUGThis feature is obtained through a ceramic ignitioncandle with a metal electrode. Keep thesecomponents well clean to prevent di