Zanussi ZKF 641 X ZAN. AUSTR Manual de usuario descargar pdf (Pagina 15)

Installation Instructions

Important! The new appliance may only be in-

stalled and connected by qualified person-

nel.

Please observe this instruction, otherwise the

warranty will not cover any damage that may

occur.

Technical Data

Appliance dimensions

Worktop cut-out dimensions

Cooking rings

Regulations, Standards,

Directives

This appliance meets the following standards:

• EN 60 335-1 and EN 60 335-2-6

relating to the safety of electrical appliances for

household use and similar purposes and

• EN 60350, or DIN 44546 / 44547 / 44548

relating to the operating features of electric coo-

kers, hobs, ovens, and grills for household use.

• EN 55014-2

• EN 55014

• EN 61000-3-2

• EN 61000-3-3

• relating to basic requirements for electro-magnetic

compatibility protection (EMC).

5 This appliance complies with the following EU

Directives:

• 73/23/EWG dated 19.02.1973 (Low Voltage Direc-

tive)

• 89/336/EWG dated 03.05.1989 (EMC Directive in-

cluding Amending Directive 92/31/EWG).

1 Safety Instructions for

the Installer

• A device must be provided in the electrical installa-

tion which allows the appliance to be disconnected

from the mains at all poles with a contact opening

width of at least 3 mm.

Suitable isolation devices include line protecting

cut-outs, fuses (screw type fuses are to be re-

moved from the holder), earth leakage trips and

contactors.

• In respect of fire protection, this appliance corre-

sponds to EN 60 335-2-6. This type of appliance

may be installed with a high cupboard or wall on

one side.

• Drawers may not be fitted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted

must satisfy the stability requirements of

DIN 68930.

• For protection against moisture, all cut surfaces

are to be sealed with a suitable sealant.

• On tiled work surfaces, the joints in the area where

the hob sits must be completely filled with grout.

• Ensure that the seal is correctly seated against the

work surface without any gaps. Additional silicon

sealant must not be applied; this would make re-

moval more difficult when servicing.

• The hob must be pressed out from below when re-

moved.

For Australia:

• CAUTION: The surface temperature exceeds 95°C.

To avoid a hazard, underbench access must be re-

stricted.

• The cable used to connect the appliance to the

mains electricity supply must have a minimum

temperature rating of V90HT for the complete dis-

tance of cable run under the hob.

Width 572 mm

Depth 502 mm

Height 47 mm

Width 560 mm

Depth 490 mm

Corner radius R5

Position Diameter Power

Front left 180mm 1700W

Rear left 180mm 1700W

Rear right 145mm 1200W

Front right 145mm 1200W

Connection voltage 230 V ~ 50Hz

Maximum connected load power 5,8kW

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Zanussi ZKF 641 X ZAN. AUSTR Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZKF 641 X ZAN. AUSTR