Zanussi ZV6120NK Manual de usuario descargar pdf (Pagina 9)

Problem Possible cause Remedy

The fuse is blown. Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

Activate the hob again and set

the heat setting in less than 10

seconds.

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

There is water or fat stains on

the control panel.

Clean the control panel.

An acoustic signal sounds and

the hob deactivates.

An acoustic signal sounds

when the hob is deactivated.

You put something on one or

more sensor fields.

Remove the object from the

sensor fields.

The hob deactivates. You put something on the sen-

sor field .

Remove the object from the

sensor field.

Residual heat indicator does

not come on.

The zone is not hot because it

operated only for a short time.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.

The sensor fields become hot. The cookware is too large or

you put it too near to the con-

trols.

Put large cookware on the rear

zones if possible.

comes on.

Automatic Switch Off oper-

ates.

Deactivate the hob and acti-

vate it again.

comes on.

The Child Safety Device func-

tion operates.

Refer to "Daily use" chapter.

and a number come on.

There is an error in the hob. Disconnect the hob from the

electrical supply for some time.

Disconnect the fuse from the

electrical system of the house.

Connect it again. If comes

on again, speak to an Author-

ised Service Centre.

E6 comes on. The second phase of the pow-

er supply is missing.

Check if the hob is correctly

connected to the electrical

supply. Remove the fuse, wait

one minute, and insert the fuse

again.

IF YOU CANNOT FIND A SOLUTION...

If you cannot find a solution to the problem yourself,

contact your dealer or an Authorised Service

Centre. Give the data from the rating plate. Give

also three digit letter code for the glass ceramic (it

is in the corner of the glass surface) and an error

message that comes on. Make sure, you operated

the hob correctly. If not the servicing by a service

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comentarios a estos manuales

Sin comentarios

Zanussi ZV6120NK Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZV6120NK