Zanussi ZKG7169 Manual de usuario

ENUser manualWasher DryerZKG 7169

Programme - Maximum and Minimum Temperature- Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part

Timed programmesDegree of Drying Type of Fabric Drying Load Spin SpeedSuggesteddrying timein MinutesSuitable for items to put awaywithout ironing1)Cot

Tar stains: first treat with stain remover, me-thylated spirits or benzine, then rub with deter-gent paste.Detergents and additivesGood washing result

• Also, fabrics containing residue of setting lo-tions or hair sprays, nail solvents or similarsolutions must not be machine dried in orderto avoid th

2. After pressing button 7: it will be impossi-ble to change any other programme or op-tion.To enable or disable this option press simulta-neously for

different speed. The relevant pilot light illumi-nates.Select the available options by pressingthe buttons 5 and 6Depending on the programme, differen

tion. Start the new programme by pressing but-ton 7 again.The washing water in the tub will be not emp-tied out.Interrupting a programmePress the butt

3. Select the drying programme for Cottonsor Synthetic in the Drying sector of theprogramme selector dial.4. If you wish to select an automatic drying

NON-STOP programme - Washing andTimed DryingThe recommended load size is 3 kg for cottonand 2 kg for synthetic.It is also possible to dry up to 4 kg o

Remove the drawerby pressing the catchdownwards and bypulling it out. Flush itout under a tap, to re-move any traces ofaccumulated powder.To aid clean

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _ _

Pull back the drainage duct.Unscrew the filter and remove it.Remove fluff and objects from the pump.Make sure that the impeller of the pump canturn. I

35°45°• Screw the hose back to the machine andmake sure the connection is tight.• Turn on the water tap.Frost precautionsIf the machine is installed i

Problem Possible cause/SolutionThe washing machine doesnot start:The door has not been closed. • Close the door firmly.The plug is not properly insert

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too much foam)has been used.• Reduce th

Problem Possible cause/SolutionThe machine makes an un-usual noise:The machine is fitted with a type of motor which makes an unusual noisecompared wit

Electrical connectionVoltage - Overall power - FuseInformation on the electrical connection is given on the rating plate, onthe inner edge of the appl

After removing all thepackaging, carefullylay machine on it'sback to remove thepolystyrene basefrom the bottom.Remove the powersupply cable and t

Caution! Before connecting up theappliance to new pipework or to pipeworkthat has not been used for some time, run off areasonable amount of water to

The drain hose may be extended to a maxi-mum of 4 metres. An additional drain hoseand joining piece is available from your localService Force Centre.

In the event of having to change the fuse in theplug supplied, a 13 amp ASTA approved(BS1363/A) fuse must be used.Warning! A cut off plug inserted int

• Do not change the specification of this appliance.• Obey the maximum load volume of 6 kg (refer to the “Programmechart” chapter). Safety instruction

30 www.zanussi.com

31www.zanussi.com

www.zanussi.com/shop 132922840-A-232012

If you stop the appliance before the end ofthe drying cycle, immediately remove andspread out all items, so that the heat can dis-sipate.• If you use

Product description1Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain pump6Adjustable feet123456Detergent dispenser draw

Control panelOn the following page there is a picture of the control panel. It shows the programme selectordial as well as the buttons, pilot lights a

from 10 minutes to 250 minutes (4.10). ForSynthetics you can select a drying time from 10minutes to 130 minutes (2.10). Every time youpress this butto

• Delayed startThe Selected delay set by pressing the relevant button appears on the display for a few sec-onds, then the duration of the selected p

Programme - Maximum and Minimum Temperature- Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part