Zanussi ZSF 6280 Instrucciones de operaciones descargar pdf (Pagina 39)

Connecting the dishwasher

Connecting to the water

supply

• The dishwasher can be connected to cold and hot

water supplies up to max. 60°C.

• The dishwasher must not be connected to open

hot water appliances or instantaneous water heat-

ers.

Permitted water pressure

Connecting the inlet hose

1 The water inlet hose must not be kinked,

crushed or entangled when it is being con-

nected.

Connect the threaded hose fitting (ISO 228-1:2000)

on the water inlet hose to a tap with an external

thread (¾ inch). The inlet hose is fitted with either a

plastic or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make

sure that the tap is not dripping.)

3 So that access to the tap in the kitchen is not

restricted by the use of the dishwasher, we

recommend installing an additional tap, or fit-

ting a T-branch to the existing tap.

If you need a longer water inlet hose than that sup-

plied, the following VDE-approved complete hose

sets are to be used. These are available from your lo-

cal service centre.

Water drainage

Drain hose

1 The drain hose must not be kinked, crushed or

entangled.

Connecting the drain hose:

– Maximum permitted height: 1 metre.

– Minimum required height: 40 cm above the bot-

tom edge of the appliance.

Lowest permitted water pressure:

1 bar (=10 N/cm2 =100 kPa)

Consult your plumber if the water pressure is less than

1 bar.

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

If the water pressure is greater than 10 bar, a pressure

reduction valve must be used (available from your

dealer).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios

Zanussi ZSF 6280 Instrucciones de operaciones Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Lavaplatos Zanussi ZSF 6280