Zanussi ZCM64DCX Manual de usuario descargar pdf (Pagina 15)

Before installing the cooker, it is necessary to

assemble the supplied feet. You can find them

into the oven cavity.

1. Remove the hob pan supports, the burner caps and

crowns and the oven accessories.

2. Carefully lean the cooker on its back (Fig. 14), paying

attention not to cause any damage.

3. Adjust the feet height by unscrewing the bottom part

of each foot, until you obtain the required height

(height can be adjusted from 850 to 880 mm).

4. Screw the feet into the relevant supports indicated

in Figure 14.

5. Lift the cooker in vertical position. Replace the

crowns, the burner caps, the hob pan supports and

the oven accessories.

6. If necessary, adjust the cooker horizontal levelling

by turning the bottom part of the feet, until the

appliance is completely stable. (Fig. 15).

Feet Assembly

FO 2285

Fig. 15

100

650

100

500

650

500

Location

Choose a location free of draughts and open doors and

clear of combustible materials or other fire hazards such

as curtains, etc. The location should ensure convenience

of operation and service. Any adjacent wall surface

situated within 200mm from the edge of any hob burner

and above the height of the hob must be a suitable non-

combustible material for a height of 150 mm for the entire

depth and width of the cooker. If the hob is below the

bench top, a clearance of 100 mm must be provided.

Any combustible material above the hotplate must be

at least 650 mm above the top of the hob and no

construction shall be within 450 mm above the top of

the burner.

Fig. 13

Fig. 14

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Zanussi ZCM64DCX Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCM64DCX