Zanussi ZEM6732FBA Manual de usuario descargar pdf (Pagina 7)

Residual heat indicator

WARNING!

There is a risk of burns from

residual heat.

The induction cooking zones make the heat

necessary for cooking process directly in the

bottom of the cookware. The glass ceramic is

heated by the heat of the cookware.

Daily use

WARNING!

Refer to Safety chapters.

Activating and deactivating

Touch for 1 second to activate or deactivate

the hob.

Automatic Switch Off

The function deactivates the hob

automatically if:

• all cooking zones are deactivated,

• you do not set the heat setting after you

activate the hob,

• you spill something or put something on the

control panel for more than 10 seconds (a

pan, a cloth, etc.). An acoustic signal sounds

and the hob deactivates. Remove the object

or clean the control panel.

• the hob gets too hot (e.g. when a saucepan

boils dry). Let the cooking zone cool down

before you use the hob again.

• you use incorrect cookware. The symbol

comes on and the cooking zone deactivates

automatically after 2 minutes.

• you do not deactivate a cooking zone or

change the heat setting. After some time

comes on and the hob deactivates.

The relation between the heat setting and

the time after which the hob deactivates:

Heat setting The hob deacti-

vates after

, 1 - 2

6 hours

3 - 4 5 hours

5 4 hours

6 - 9 1.5 hour

The heat setting

To set or change the heat setting:

Touch the control bar at the correct heat setting

or move your finger along the control bar until

you reach the correct heat setting.

Bridge function

This function connects two left side cooking

zones and they operate as one.

First set the heat setting for one of the left side

cooking zones.

To activate the function: touch

. To set or

change the heat setting touch one of the control

sensors.

To deactivate the function: touch . The

cooking zones operate independently.

Automatic Heat Up

If you activate this function you can get a

necessary heat setting in a shorter time. The

function sets the highest heat setting for some

time and then decreases to the correct heat

setting.

To activate the function the cooking

zone must be cold.

To activate the function for a cooking

zone: touch ( comes on). Immediately

touch the correct heat setting. After 3 seconds

comes on.

To deactivate the function: change the heat

setting.

www.zanussi.com 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comentarios a estos manuales

Sin comentarios