Zanussi ZGO96524BA Manual de usuario descargar pdf (Pagina 11)

Serial number ...........................

Gas Connection

WARNING!

The following instructions about

installation, connection and

maintenance must be carried out by

qualified personnel in compliance

with standards and local regulations

in force.

Choose fixed connections or use a flexible pipe

in stainless steel in compliance with the

regulation in force. If you use flexible metallic

pipes, be careful they do not come in touch with

mobile parts or they are not squeezed. Also be

careful when the hob is put together with an

oven.

Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The

adjustable connection is fixed to the

comprehensive ramp by means of a

threaded nut G 1/2". Screw the

parts without force, adjust the

connection in the necessary

direction and tighten everything.

A

B

B

C

D

A. End of shaft with nut

B. Washer

C. Elbow (if needed)

D. Rubber pipe holder for liquid gas

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue with

the gas connection.

The flexible pipe is prepared for apply when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting edges or

corners;

• it can be easily examined in order to make

sure its condition.

The control of preservation of the flexible pipe

consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows its

correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not repair

the pipe, but replace it.

WARNING!

When installation is complete, make

sure that the seal of each pipe fitting

is correct. Use a soapy solution, not

a flame!

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).

A

WARNING!

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the

minimum position.

www.zanussi.com 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios