Zanussi ZGX9641F Manual de usuario descargar pdf (Pagina 6)

DESCRIPTION OF THE APPLIANCE

OVERALL DIMENSIONS

MEASURES APPLIANCE

MEASURES BUILDING-IN

INSTRUCTIONS DESTINED

TO THE INSTALLER

SECOND PART

ASSEMBLAGE AND INSTALLATION OF THE APPLIANCE

This appliance has to be placed in a top with height from 30 mm

to 40 mm.

1) Proceed to the cut of the top in accordance with the measures

indicated in the general descriptions of the appliance dimensions.

2) Set sealing strip X between cooking table and top.

3) Insert the cooking table in the top and fix it by means of fixing

clamps Y, screwing of some turns screw Z (see picture below).

4) When the appliance is installed so that its lower part can be

touched, we recommend to place a protecting wall. This

protection, withstanding high temperatures, must be placed at

least 20 mm. from the lower part of the appliance.

WARNINGS

Before performing any repair or operation, switch the appliance

off and close the gas tap. The qualified engineer is responsible

for correct installation according to the safety standards in

force.

The earthing of the appliance is legally binding. The manufacturer

declines all responsibility for any damage to persons, animals or

things caused by failure to observe the above mentioned rules.

The technical data are indicated on the data nameplate placed

on the rear of the appliance.

The adjustment conditions are stated on the label applied on the

packaging and on the appliance.

Keep the injectors provided; they could be necessary to adjust

the appliance with a different gas.

INSTALLATION

IMPORTANT: The coating of the forniture must be able to withstand

high temperatures (min. 90°C).

This appliance belongs to class X against fire dangers.

This means that the appliance can not be installed near cabinet,

whose height is higher than the appliance work top.

Note: For all appliances with triple crown burner placed on the

left side of the hob, it is necessary than the left wall of the forniture

is at least 100 mm from the hob end.

In case that units are above the appliance, these must be placed

at a minimum distance of 800 mm from the appliance top.

ASSEMBLING OF THE GLASS LID ON THE HOB

Remove stoppers P from the holes in the rear part of the hob.

Place lateral upper support T, and fix everything by means of the

two screws V.

The same procedure must be followed for the other lateral upper

support T.

For the assembling of the lid, introduce it into the relevant slots

on the two lateral upper supports T.

Z Y

480

840

500

HOB P6

4 GAS BURNERS WITH TRIPLE CROWN BURNER

5 GAS BURNERS WITH LONG "FISH" BURNER

5 GAS BURNERS WITH TRIPLE CROWN BURNER

3 GAS BURNERS WITH TRIPLE CROWN BURNER

4 GAS BURNERS WITH AN ELECTRIC PLATE

DESCRIPTION

A Work-top

B Left grid for hob

C Rapid burner

D Triple crown burner

E Semirapid left burner

F Central grid for fish burner

G Central grid for triple crown burner

H Central grid

I Fish burner

J Electric plate Ø 145

K Semirapid right burner

L Right grid for hob

M Holder for mark label

N Gas knob

O Warning light for plate

P Electric knob

Q Ignition button

R Auxiliary burner

S Triple crown burner

T Control grid

4 GAS BURNERS

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Zanussi ZGX9641F Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZGX9641F