Zanussi ZCV55321WA Manual de usuario Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V, 40 W,
300 °C heat resistant lamp.
4. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem Possible cause Remedy
You cannot activate the appli-
ance.
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
You cannot activate or operate
the hob.
The fuse is blown. Activate the hob again and set
the heat setting in less than 10
seconds.
Residual heat indicator does
not come on.
The zone is not hot because it
operated only for a short time.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
The oven does not heat up. The oven is deactivated. Activate the oven.
The necessary settings are not
set.
Make sure that the settings are
correct.
The clock is not set. Set the clock.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
It takes too long to cook the
dishes or they cook too quick-
ly.
The temperature is too low or
too high.
Adjust the temperature if nec-
essary. Follow the advice in the
user manual.
The display shows "12.00". There was a power cut. Reset the clock.
21
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios