Zanussi ZOG21411XK Manual de usuario descargar pdf (Pagina 15)

D

E

F

1. Remove the bottom plate of the oven cavity

(A) to get access to the gas oven burner

(B).

2. Release the two screws (C), which keep

the gas oven burner in position.

3. Carefully move the gas oven burner off the

injector support (D).

Slowly move it to the left side. Make sure

that the gas oven burner bush stays on the

burner mouthpiece. Do not apply force to

the wire of the spark plug connector (E)

and to the thermocouple conductor (F).

4. Unscrew the gas burner injector (D) with a

7 mm socket spanner and remove it. Re-

place it with the necessary one (see table

„Gas Oven Burner Data“).

5. Assemble the gas oven burner in opposite

sequence.

6. Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type (supplied with the injector

kit).

Warning! A primary air adjustment of the

gas oven burner is not necessary.

Minimum level adjustment of the gas

oven burner:

1. Disconnect the mains plug from the mains

socket.

2. Turn the control knob to the minimum posi-

tion and remove it.

3. Adjust the adjustment screw (A) with a thin

bladed screwdriver.

A

Change of type of

gas

Adjustment of the

adjustment screw

from natural gas to

liquid gas

fully tighten the ad-

justment screw in

from liquid gas to nat-

ural gas

release the adjust-

ment screw approxi-

mately 1/2 of a turn

Only for Russia:

from liquid gas to nat-

ural gas 13 mbar

release the adjust-

ment screw approxi-

mately 3/4 of a turn

from natural gas 20

mbar to natural gas

13 mbar

release the adjust-

ment screw approxi-

mately 1/4 of a turn

4. Attach the gas oven control knob.

5. Put the mains plug into the mains socket.

Warning! Only put the mains plug into the

mains socket when all parts are put back

into their initial position.

6. Light the gas oven burner (see section

„Gas oven cooking - Ignition of the oven

gas burner“).

7. Set the gas oven control knob to 240 and

let the oven heat for 10 minutes minimum.

8. Turn the gas oven control knob from 240

to minimum.

Control the flame. If the flame goes out, do the

procedure from point 1 to point 7 again. There

must be a small regular flame on the gas oven

burner crown.

The manufacturer objects liability if you

do not obey to this safety measures.

Building In

Conditions for building-in:

• Only set up the appliance in a kitchen or in a

kitchen-dining room.

15

www.zanussi.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Comentarios a estos manuales

Sin comentarios