Zanussi ZCE560NW1 Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
10
The Hotplates
Spills onto the actual plate should be removed using
warm water and a soft brush, nylon or plastic
scourer. To keep the plates looking as new, hotplate
conditioner can be purchased from most hardware
stores, e.g. “4 Hob” by Home Care Products (follow
the manufacturer’s instruction for use).
Alternatively, wipe the plates with a drop of olive oil
on a kitchen towel to avoid rust. It is important to
note that the plate will smoke a little and produce a
slightly unpleasant odour when next used.
Drying
Important: After cleaning, dry the hotplates thoroughly by
switching on to a low-medium setting for a few minutes.
Restoring
To maintain the appearance of your sealed hotplates
apply a little salt-free vegetable oil or restorative
agent periodically.
To apply vegetable oil: first heat the hotplate on a
medium setting for 30 seconds then turns off. Pour a
very small amount of salt-free oil onto a dry cloth or
kitchen paper. Apply a thin coat of oil to the hotplate
surface and wipe off any excess. Heat the hotplate
on a medium setting for 1 minute.
Stainless steel parts: the stainless steel spill rings
may become straw coloured with use. Use a
proprietary stainless steel cleaner to remove this
straw discolouration. This also applies to the area
around the hotplates on stainless steel hobs.
Cleaning the oven door
Removing oven door from its hinges
To make it easier to clean the oven, the oven door
can be removed.
Open the oven door into the horizontal position.
Then lift up the clips on the two door hinges as far as
they will go (a).
Slowly close the door again as far as the stop and lift
the door until the hinges come out (b).
Replacing the oven door on its hinges
When putting the door back on its hinges, reverse the
procedure for removing the door from its hinges.
Re-insert the door’s hinges into the slots (c). When you
do this, make sure the hinges engage properly and
evenly.
Then slowly lower the door downwards. When you do
this, make sure the corners of the door do not touch the
bottom of the frame (if this happens, lift the door up
again and realign the hinges).
Finally fold the clips back down towards the oven (d). So
that the door closes properly, press down on the clips
with something (e.g. a screwdriver) (e).
Slowly check the correct operation of the door.
Important: Never leave the door hinge levers standing
up. Otherwise the spring action can lead to injury.
Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass since
they can scratch the surface, which may result in
shattering of the glass.
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios