Zanussi ZCG61211WA Manual de usuario descargar pdf (Pagina 22)

• expired term is not due.

If one or more defects are visible, do not repair

the pipe, but replace it.

WARNING!

When installation is complete, make

sure that the seal of each pipe fitting

does not leak. To check the seal use

a soap solution, not a flame.

The gas supply ramp is on the rear side of the

control panel.

WARNING!

Before you connect the gas,

disconnect the appliance from the

electricity supply or switch off the

fuse in the fuse box. Close the

primary valve of the gas supply.

The appliance is set to default gas.

To change the setting choose a pipe

holder from the list. Always use the

gasket sealing.

A B C

DE

A) Gas connection point (only one point is

applicable for the appliance)

B) Gasket

C) Adjustable connection

D) Natural Gas pipe holder

E) LPG pipe holder

Adjustment to different types of gas

WARNING!

Let only an authorized person do the

adjustment to different types of gas.

This appliance works with liquid gas.

With the correct injectors, you can

also operate it with natural gas. The

gas rate is adjusted to suit.

WARNING!

Before you replace the injectors,

make sure that the gas knobs are in

the Off position. Disconnect the

appliance from the electrical supply.

Let the appliance cool down. There

is a risk of injury.

Hob injectors replacement

Replace the injectors when you change the gas

type.

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. Remove the injectors with a socket spanner

7.

4. Replace injectors with the ones necessary

for the type of gas you use.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply.

You can find this plate in the

bag supplied with the appliance.

If the supply gas pressure is not constant or it is

different from the necessary pressure, install an

applicable pressure adjuster on the gas supply

pipe.

Adjustment of minimum level at the hob

burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there is no

access to the bypass screw dismount the

control panel before adjustment start.

3. Adjust the bypass screw (A) with a thin and

flat screwdriver.

Positions of the bypass screw (A) depends

on model.

22 www.zanussi.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios