Zanussi ZCG61211WA Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
Turnspit
For roasting larger joints of meat and poultry.
Grill deflector
To protect the knobs when you use the grill.
Storage compartment
The storage compartment is below the oven
cavity.
To use the compartment, lift the lower front
door then pull down.
WARNING!
The storage compartment can
become hot when the appliance
operates.
Before first use
WARNING!
Refer to Safety chapters.
Initial Cleaning
Remove all accessories from the appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance before first use.
Put the accessories back to their initial position.
Preheating
Preheat the empty appliance to burn off the
remaining grease.
1. Set the maximum temperature.
2. Let the appliance operate for approximately
1 hour.
WARNING!
Accessories can become hotter than
usual.
The appliance can emit an odour and smoke.
This is normal. Make sure that the airflow is
sufficient.
Let the oven cool down. Dampen a soft cloth
with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.
Hob - Daily use
WARNING!
Refer to Safety chapters.
Ignition of the burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Push and hold the spark generator button
.
2. At the same time turn the knob for the hob
counterclockwise to the maximum gas flow
position
and push it down to light the
burner.
3. Release the spark generator button when
burner lights but keep the knob on this
position for equal or less than 10 seconds
to let the thermocouple warm up. If not, the
gas supply will be interrupted.
4. Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the burner
does not light after 15 seconds,
release the knob, turn it into the off
position and try to light the burner
again after minimum 1 minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
www.zanussi.com 7
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentarios a estos manuales

Sin comentarios