Zanussi ZCG61211WA Manual de usuario descargar pdf (Pagina 24)

Positions of the bypass screw (A) depends

on model.

A

Change from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Change form liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position (A).

2. Put the knob back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts are

back into their initial position.

There is a risk of injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob on the minimum position.

6. Remove the knob again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob back.

9. Set the maximum gas flow position on the

oven knob and let the oven heat for at least

10 minutes.

10. Quickly turn the knob for the oven functions

from maximum to the minimum gas glow

position.

Control the flame. Make sure the flame does not

go out when you turn the knob to the minimum

gas flow position. There must be a small regular

flame on the oven burner crown. If the flame

goes out adjust the oven burner again.

Gas grill injector replacement

1. Release the screws which keep the grill

burner in position (A).

A

2.

Release the burner injector with a 7 mm

socket spanner and replace it with a

different one.

3. Assemble the burner in a reverse sequence.

Before you fix the screw, make sure that the

burner is pushed correctly to the back

panel.

Test the grill injectors.

Electrical installation

WARNING!

The manufacturer is not responsible

if you do not follow the safety

precautions from Safety chapters.

This appliance is supplied with a main plug and

a main cable.

WARNING!

The power cable must not touch the

part of the appliance shown in the

illustration.

24 www.zanussi.com

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios