Zanussi ZKS851DX Manual de usuario Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
appliance has cooled down using cleaner for glass
ceramic or stainless steel.
What to do if ...
Problem/Display Possible Cause Remedy
The cooking zones cannot be
switched on or are not operating
More than 10 seconds have passed
since the appliance was switched
on
Switch the appliance on again.
The lock is switched on
Switch off the lock (See the section
“Locking/unlocking the control pan-
el”)
The child safety device is switched
on
Deactivate child safety device (see
the section "Child safety device")
Several sensor fields were touched
at the same time
Only touch one sensor field
Automatic switch-off has been trig-
gered
Remove any objects (pans, etc.)
that are lying on the control panel.
Switch appliance on again
There is water on the control panel
or the control panel is covered with
fat splashes
Wipe the control panel
STOP+GO is activated
Switch off STOP+GO
Display is switching between two
heat settings
Power management is reducing the
power of this cooking zone
See the section “Switching the pow-
er function on and off”
The residual heat indicator is not
displaying anything
The cooking zone was only on for a
short time and is therefore not hot
If the cooking zone is supposed to
be hot, call your local Service Force
Centre.
lights up
Unsuitable cookware Use suitable cookware
No cookware on the cooking zone Put cookware on zone
Diameter of the base of the cook-
ware is too small for the cooking
zone
Move to smaller cooking zone Use
suitable cookware
lights up
Automatic switch-off has been trig-
gered
Switch appliance off. Switch appli-
ance on again
and number are displayed
Electronics fault Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house’s
wiring system) If after switching on
again,
is displayed again, call
the customer service department
12
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios