
Switching the appliance on and off
Control panel Display
To switch on
Touch for 1 second
lights up. The operational readiness indicators of the
individual cooking zones also light up.
To switch off
Touch for 1 second
goes out. The operational readiness indicators of the
individual cooking zones also go out.
After switching on, within approx. 10 seconds a
heat setting or a function must be set, otherwise
the appliance automatically switches itself off.
Setting the heat setting
The control bar is touched where the desired heat set-
ting is positioned. The heat setting is shown in the dis-
play. Correct to the left or the right, if necessary. Do not
release before the desired heat setting is reached.
Locking/unlocking the control panel
The control panel, with the exception of the “On/Off”
sensor field, can be locked at any time in order to pre-
vent the settings being changed e.g. by wiping over the
panel with a cloth.
Control panel Display
To switch on
Touch
Indicator lights up
To switch off
Touch
Indicator goes out
When you switch the appliance off, the locking function is automatically switched off.
Switching the STOP+GO function on and off
The STOP+GO function simultaneously switches all
cooking zones that are switched on to the keep warm
setting and then back to the heat setting that was pre-
viously set.
Control panel Display
To switch on
Touch
To switch off
Touch
Heat setting that was previously set (not automatic warm up function)
STOP+GO does not stop the Timer function.
STOP+GO locks the whole control panel except
the sensor field .
Using the automatic warm-up function
All cooking zones are equipped with an automatic
warm-up function. When setting a heat setting using
the automatic warm-up function, the cooking zone
switches to full power for a certain amount of time and
then automatically switches back to the heat setting set.
5
Comentarios a estos manuales