
Problem Possible cause Remedy
The flame colour is orange or
yellow.
The flame can look orange or
yellow in some areas of the
burner. This is normal.
The oven does not heat up. The oven is deactivated. Activate the oven.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not
set.
Make sure that the settings are
correct.
The turnspit does not rotate. The turnspit is not correctly in-
stalled into the turnspit hole.
Refer to "Using the turnspit".
It takes too long to cook the
dishes or they cook too quick-
ly.
The temperature is too low or
too high.
Adjust the temperature if nec-
essary. Follow the advice in the
user manual.
The display shows an error
code that is not in this table.
There is an electrical fault. Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
The display shows "12.00". There was a power cut. Reset the clock.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
21
Comentarios a estos manuales