
16
Pipe
flexible
Pipe
flexible
Rigid pipe
• Rigid pipe with screw nut.
2. For cylinder butane propane gas:
• We advise you to use flexible pipe according to
the national rule in force of minimum 1 m; this
length is chosen depending on the position of
the connection to the gas supply;
• For the old butane installations you can use a
flexible rubber pipe of max 1,5 m and 6 mm
diameter, mounted with the special butane
holder (see figure);
• Fix it well by means of a collar for each end.
Fitting
Necklace
Holder
butane
Flexible
rubber
The appliance can be connected to the gas supply on
the right by one print of connection. The end of the
distributing pipe is threaded.
It is necessary to route the connecting hose (flexible)
at the back of the appliance as shown in the diagram
(see fig. 22). Ensure that the rubber hose is not in
contact with any part of the hatched area shown in
the diagram. The hose has to be fixed in the support
by means of the clamp supplied. The hose should not
have narrow curves or throttlings. Check tightness
with soapy water.
Electrical connection
Any electrical work required to install this
hob should be carried out by a qualified
electrician or competent person, in accordance
with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the rating
plate.
Note:
In case of a direct connection to the mains you have
to interpose an omnipolar switch a minimum opening
between contacts of 3 mm.
The switch should be sited within 2 m of the hob and
be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
Ensure that the supply cord is not in contact with any
part of the hatched area shown in the diagram (see
figure).
NOTE: The earth wire should be about 4 cm
longer than the live and neutral wires.
To use cable type H05 RR-F with the section
indicated in the table no.1.
Before connecting check that:
• fuse and household electric installation can bear
the charge of the appliance (see rating plate);
clamp
connection of
flexible hose
Comentarios a estos manuales