
After igniting the oven gas burner
1. Release the knob for the oven functions.
2. Close the oven door.
3. Turn the knob for the oven functions to set
the necessary heat setting.
Control the flame trough the holes in the bottom
of the oven.
Turning off the oven burner
To put out the flame, turn the knob to the off
position .
Using the grill
The grill temperature cannot be
adjusted. To get a lower temperature
or slower cooking time, lower the
grill pan away from the flame.
Before you use the grill, put the grill deflector
(A) into the place above the door. Make sure
that the two catches fit correctly in the holes in
the top part of the front frame of the oven cavity
(underneath the control panel).
Do not put the meat directly on the
tray or pan.
CAUTION!
Do not put the meat on the highest
shelf level. There is a risk of fire.
1. Open the oven door.
2. Push and hold the spark generator button.
3. Turn the oven control knob to Grill position
. Push the knob in and hold.
4. Release the spark generator button.
5. Keep the oven control knob in this position
for approximately 15 seconds. Do not
release it until the flame comes on.
6. Release the oven control knob.
If the grill does not come on or if it accidentally
goes out release the oven control knob and turn
it to the Off position. Open the oven door. After
one minute, try to light the grill again.
7. Preheat the grill for 5 to 10 minutes.
8. Put the oven shelf with the meat on shelf
position 3.
9. Put a baking tray or roasting pan below, on
shelf position 2, to collect the juices.
10. Keep the oven door slightly open.
If there is temporarily no power supply open the
oven door, put the grill deflector and hold a
flame near the grill burner holes and turn the
oven knob to the Grill position .
Turning off the grill burner
To put out the flame, turn the knob to the off
position .
Oven - Clock functions
Minute Minder
Use it to set a countdown time.
This function has no effect on the
operation of the appliance.
Turn the knob for the timer as far as it goes,
then turn it to necessary time period.
After the time period is completed, an acoustic
signal sounds.
www.zanussi.com 11
Comentarios a estos manuales