Zanussi ZCM661NX Manual de usuario descargar pdf (Pagina 24)

by-pass screw

Adaptation to different kinds of gas

To adapt the appliance to a different kind of gas from

the one the appliance has been set for, follow the

instructions below in their order.

Gas connection

LPG: use the rubber pipe holder «D».

Natural gas : use the pipe holder «E».

Always insert the gasket sealing «B». Then

proceed with the gas connection, as indicated in the

relevant paragraphs.

Hob burners nozzles

1. Nozzles replacement

1. Remove the pan supports.

2. Extract the caps and the wall baffles of the burn-

ers.

3. Using a socket spanner 7 unscrew and remove

(see diagram) the nozzles replacing them with

the ones required for the kind of gas in use (see

table “Burner characteristics”).

4. Reassemble the parts following the same proce-

dure backwards.

5. Replace the rating label (placed near the gas

supply pipe) with the relevant one for the new

type of gas supply. You can find this label in the

package of the injectors supplied with the appli-

ance.

These burners do not need any primary air

regulation.

2. Adjustment of minimum level

To adjust the minimum level of the burners,

proceed as follows:

1. light the burner;

2. turn the knob on the position of minimum flame;

3. remove the knob;

4. with a thin screwdriver, adjust the by-pass screw

(see diagram).

• If changing from natural gas 20 mbar to liquid

gas, completely tighten the adjustment screw

in, until a small regular flame is obtained.

• If changing from liquid gas to natural gas 20

A Gas connection point

B Gasket

C Adjustable connection

D LPG rubber pipe holder

E Natural gas pipe holder

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios

Zanussi ZCM661NX Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCM661NX