Zanussi ZCV660MW Manual de usuario descargar pdf (Pagina 15)

Removing the oven door and the glass panel

Open the door fully

and hold the two door

hinges.

Lift and turn the levers

on the two hinges.

Close the oven door to

the first opening position

(halfway). Then pull for-

ward and remove it from

its seat.

Place the door on a

stable surface protected by

a soft cloth.

Use a screwdriver to re-

move 2 screws from the

bottom edge of the door.

Important! Do not lose the

screws.

Use a spatula made of

wood or plastic or equiva-

lent to open the inner

door.

Hold the outer door, and

push the inner door

against the top edge of the

door.

Lift the inner door.

Clean inner side of the

door.

Clean the glass panel with

water and soap. Dry it

carefully.

Warning! Only clean the glass panel with water and

a soap. Abrasive cleaning agents, stain removers

and sharp objects (e.g. knives or scrapers) can cause

damage to the glass.

Inserting the door and the glass panel

When the cleaning procedure is completed, insert the

oven door. To do so, do the steps in opposite way.

Oven lamp

Warning! Be careful when you change the oven

lamp. There is a risk of electrical shock.

Before you change the oven lamp:

• Deactivate the oven.

• Remove the fuses in the fuse box or deactivate the cir-

cuit breaker.

Put a cloth on the bottom of the oven to prevent

damage to the oven light and glass cover.

1. Turn the glass cover counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the oven light bulb with applicable 300°C

heat-resistant oven light bulb.

Use the same oven lamp type.

4. Install the glass cover.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comentarios a estos manuales

Sin comentarios

Zanussi ZCV660MW Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCV660MW