Zanussi ZCV6602MW Manual de usuario descargar pdf (Pagina 19)

• Remove the fuses in the fuse box or switch off the cir-

cuit breaker.

Put a cloth on the bottom of the oven for protection

of the oven light and glass cover.

Replacing the oven lamp

1. You can find the lamp glass cover at the back of the

cavity.

Turn the lamp glass cover counterclockwise to re-

move it.

2. Clean the glass cover.

3. Replace the oven lamp with applicable 300°C heat-

resistant oven lamp.

Important! Use the same oven lamp type.

4. Install the glass cover.

Removing the drawer

The drawer below the oven can be removed for cleaning.

1. Pull the drawer out until it stops.

2. Lift the drawer at a small angle and remove it from

the drawer support rails.

Inserting the drawer

1. Set the drawer on the support rails. Make sure that

the catches engage correctly into the rails.

2. Lower the drawer until it is horizontal and push it in.

Warning! When the oven is in use, heat can build up

in the drawer. Do not keep flammable things in there

(e.g. cleaning materials, plastic bags, oven gloves, paper,

cleaning sprays, etc.).

What to do if…

Warning! Refer to "Safety information" chapter.

Problem Possible cause Remedy

The residual heat indicators does not

come on

The cooking zone is not hot because

it operated only for a short time

If the cooking zone must be hot,

speak to the after sales service

The appliance does not operate The fuse in the fuse box is released Control the fuse. If the fuse is re-

leased more than one time, refer to a

qualified electrician.

The oven does not heat up The oven is not switched on Switch on the oven

The oven does not heat up The necessary settings are not set Control the settings

The oven lamp does not operate The oven lamp is defective Replace the oven lamp

Steam and condensation settle on the

food and in the oven cavity

You left the dish in the oven for too

long

Do not leave the dishes in the oven

for longer than 15-20 minutes after

the cooking process ends

If you cannot find a solution to the problem yourself, con-

tact your dealer or the service centre.

The necessary data for the service centre is on the rating

plate. The rating plate is on the front frame of the oven

cavity.

We recommend that you write the data here:

Model (MOD.) .........................................

www.zanussi.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comentarios a estos manuales

Sin comentarios

Zanussi ZCV6602MW Manual de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi ZCV6602MW